ABOUT V2300 SYSTEM INVERTED MARKING PAINT
Create extra-bold markings with Rust-Oleum High Performance V2300 System Inverted Marking Paint Spray. This solvent-based paint sprays on thick and wide for best-possible visibility and durability on dirt, grass, concrete, etc.
- Creates 2-3"-wide marks
- Resists early fading and chalking
- Dries in under 5 minutes
- Guaranteed not to clog; convenient spray-through cap
- Meets USDA requirements for incidental food contact;
For Best Results
- Apply using the Marking Pistol; or Marking Wand.
SURFACE PREPARATION
ALL SURFACES: Remove loose debris and contaminants by
sweeping the surface before application of the coating.
APPLICATION
Apply when temperature is above 32°F (0°C) and humidity is
below 85% to ensure proper drying. Protect surrounding
surfaces from overspray. Overspray can carry a significant
distance. Shake can vigorously for one minute after mixing
ball is heard. If mixing ball fails to rattle DO NOT STRIKE
CAN. Contact Rust-Oleum. Invert can and point at ground or
floor. Hold the can 4-6 inches above surface to be marked.
Press in sideways to spray or use Rust-Oleum Marking
Wand item #2393000 or Marking Pistol item #210188.
Follow directions for proper use of this equipment. Keep can
moving to prevent build-up. Clean valve by spraying upright
for 2-3 seconds after each use.
CLOGGING
If clogging occurs, carefully remove spray tip and clean in
thinner. DO NOT insert any object into can valve opening.
Use care when replacing the spray tip. Properly discard
empty container. Do not burn or place in trash compactor.